Part 1 is here: [TTT] Getting started with 3D Printing with the Anet A8 Printer – Part 1 of 4 – Required Upgrades

The next part of this 4 part series is going to cover the recommended upgrades. These upgrades are not required to use the printer but will help your printer produce better, cleaner, and more accurate prints. I will go over what each one does and why it is beneficial.

Cooling Duct

The factory cooling duct is very simple and doesn’t fully cool all sides of the filament as it is extruding. This upgraded duct will ensure that there is 360 degrees of airflow going around the filament as it is being extruded. This will allow the filament to adhere and cool evenly as it is being extruded to the layers.

You can download it here from Thingiverse.


X Belt Holder

The factory way to attach the belt to the rear of the carriage is with 2 screws and a zip tie. This makes adjustment and belt replacement difficult. This holder allows you to easily adjust and remove the X axis belt by hand without any additional tools. I had this pre-printed from a friends printer before I even had the printer assembled. This made connecting the belt to the carriage much easier as well as getting the correct tension.

You can download it here from Thingiverse.


X and Y Tensioner

In addition to the upgraded mounting blocks I recommend in this post these other two addons make adjustment of the tension of bot the Y and X axis belts much easier. You can simply adjust the tension by turning the screws on the addons to change the belt tension. I should note that if you want to use the X tensioner you must cut the belt about 3″ longer than the Anet A8 guide recommends or just replace the belt with and GT2 style belt (Amazon)

You can download the X Tensioner and Y Tensioner from Thingiverse.


Y Belt Mounting and Clips

Lastly the Anet guide actually tells you to assemble the mounting plate upside down and this causes a shift and un-needed strain on the stepper motor and belt. Make sure the plate is mounted with the single bar down, not up. I have included a picture illistrating this. In addition to that you may want to print some upgraded mounting clips to further level the belt and replace the brittle acrylic ones that are included.

You can download the mounting clips from Thingiverse.

Correct Belt and Y Mounting Setup

I hope this has been helpful. If you need the parts printed and are near the Chicagoland area I would be glad to print some for fellow Anet A8 users. The next part will be coming tomorrow going over some enhancements and extras you can add on to make the printer even better. Until then have fun and let me know if you need any help!