A few months ago I posted 2 articles (Post 1 & Post 2) about upgrades to do to the Anet A8 printer. I planned on writing more guides in addition to the 2 mentioned but I quickly found that there was just too much to cover in regards to this printer. I was constantly making changes here and there to the printer so it was hard to keep up.

The bottom line is that the first 2 articles I posted are really all that you need to get good prints and make the printer reliable. Anything further than that you will be customizing the printer for a specific need that you have or want. As I write this followup my printer only has 2 things that are factory left on it; the heated bed PCB and the frame. I have replaced and upgraded every other part on the printer and even added dual color support through the single hotend. The guides were meant to get you started with the printer and to make it safer, these 2 posts did just that.

That is really all that I needed to say on the matter. There will be no other posts as I feel the ones already published cover the goal of the articles and anything further would not be applicable to everyone as people have different demands and needs for their individual printer.

If you need help and/or have questions please check out the Official Anet A8 Printer group here: https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup. I help run this group now with a few other people and it is a great place to get help with your A8 or similar printers.

I will also be attending MidWest Rep Rap Fest so let me know if you will be there as well!