CR-10 Solid Bed Mounts with Pi Camera and Wire Strain – AUTO LEVEL SENSOR REQUIRED

These are solid bed mounts for the CR-10. They are 22mm in height and get you the most out of the Z height when using them. You MUST have an autolevel sensor since you can no longer level the bed.

README:

You will need 2 of the simple mounts (look at the beginning of the file names for how many to print). I printed everything at 100% infill and drilled out the holes in the mounts to fit the screws. They may or may not be tight as is when you print them so be prepared to drill them out to get the stock screws to fit.

Print in ABS or PETG at the least due to the heat that they will be around.

Wire Strain Source: http://www.thingiverse.com/thing:2186203
Pi Camera Source: http://www.thingiverse.com/thing:1867549 

 

Creative Commons License
My bed mounts are licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. Original models are under their respective licenses.